
Re: unused analog switch sections
On Thu, 6 Mar 2008 04:08:01 -0500, "Brett Holden"
<bretth2o@bellsoh.net> wrote:
>Hello, Brett!
>You wrote to All on Thu, 6 Mar 2008 04:01:04 -0500:
>
> BH> My question is: would it be OK to tie unused "D" pins together and
> BH> unused "S" pins together - and then ground "D" or "S" through a 10k
> BH> resistor, or is there a better way of dealing with this?
>
> BH> I would appreciate any advice.
>
>Hmmm, come to think of it, what is the best thing to do with the "IN" pins?
>Can I tie them directly together then ground through a 10k resistor?
>
>Thanks again.
>
>With best regards, Brett Holden. E-mail:
bretth2o@bellsoh.net>
You only need to be concerned with the control pins. Leave the ins
and outs unconnected and tie the controls either high or low.
That will stop them from possibly toggling madly at high rates and
increasing power dissipation.
Best regards,
Bob Masta
DAQARTA v3.50
Data AcQuisition And Real-Time Analysis
http://www.daqarta.comScope, Spectrum, Spectrogram, FREE Signal Generator
Science with your sound card!